3D Printer Teensylu V0.8 Hi3D RepRap Prusa Mendel Control Board moduleboard

3D Printer Teensylu V0.8 Hi3D RepRap Prusa Mendel Control Board moduleboard3D Printer Teensylu V0. 8 Hi3D RepRap Prusa Mendel Control BoardDescription: This is a project that is based on Sanguinololu. The ATmega644P has been replaced with an Atmel AT90USB1286 MCU. This Microcontroller has on chip USB, removing the need for the FTDI USB UART. LUFA CDC bootloader preinstalled on the AT90USB1286 allows you to upload the firmware through USB cable directly. All of the through hole resistors and capacitors have been replaced with

Able to detect both metal and non-metal building platform

● Voltage: 220V

- Suit for Stepper Motor: 42HD4027-01- About the stepper motor version for your reference

There are two methods to attaching the PEI to your print bed

Suitable for Industrial automation equipment

Size:50mmX50m

the green light goes off

Other warehouses still old version

while ensuring that the motor does not lose step

But instead of adding only one additional output port the RRD-FAN-EXTENDER is equipped with 2 PWM controllable channels(D6/D11)

please skip

1 x 200*200mm 110V/220V Heater Pad